Need to know how electrical energy is being used? The GenII GD40A/AB transmitter and clip-on self powered CTs can provide the answer. The four GD40A/AB sensor inputs are designed for ND Meter SXD CTs. The transmitter is intended for use in situations where an averaged rather than instantaneous value at the time of transmission is required.
The GD40A has an external 12VDC input, and is supplied with an MP12U5W 110/220VAC power supply.
The GD40AB has an external 9VDC input, for use with a high capacity 9VDC battery.
If you require sensors, please order them separately.
| SXD5/5 | 0-5A |
| SXD10/5 | 0-10A |
| SXD20/5 | 0-20A |
| SXD30/5 | 0-30A |
| SXD50/5 | 0-50A |
| SXD100/5 | 0-100A |
| SXD200/5 | 0-200A |
Clip-on CT
This kit enables fitment of the transmitter's built-in wall bracket to difficult or uneven surfaces. The kit provides additional docking security.
The following products are supported:
WBG
| Model(s) | Sensors | Range |
| GD40A and GD40AB | 4 x voltage inputs with averaging for NDMeter SXD self powered CTs At the point of transmission the averaged value of the last 30 values, sampled every 10 seconds per channel, is sent. |
0-6VDC only |
| RF specification: | EN300-220 | |
| RF power: | 10mW | |
| Environment specification | ||
| Compliant to EN300-220: | -10 to +55°C | |
| Actual: | -30 to +65°C | |
| Humidity: | 100% non condensing | |
| Environmental rating: | IP40 | |
| Dimensions (footprint): | 78 x 41mm | |
| Transmission interval range: | 1 sec to 4 hours | |
| Indicator (red LED): | transmit active/on/off | |
| Control switch (concealed): | test mode / hibernate | |
| Antenna socket: | SMA | |
Gen II Quick Start Instructions
