Flexible Construction Joint Waterproofing System - Newton FlexProof 106
Highly advanced single-component liquid waterproofing material, which forms an elastomeric polymer membrane that is rainproof in minutes and capable of handling severe building movements and deformations.
The FlexProof 106 System is composed of two variants of the product, plus ancillaries:
- X1 − A thixotropic variant that is applied as a paste and so is suitable as a surface sealant over joints.
- NV − A lower viscosity variant that can be poured and is typically used within movement joints.
- FlexProof 106 Primer (Product code: 916) − Improves adhesion to porous surfaces.
- FoamStop (Product codes: FS1 to FS8) − Foam backing rod for movement joints.
Other Products and Services from Newton Waterproofing
Newton Newtonite 801 Sealing Mastic for Sealing Penetration & Preventing Bridging
A multipurpose silicone sealant primarily used with the NewLath 805 Mesh Membrane and Newtonite 803 Membranes - applied to the plug before fixing into the membrane, 801 Mastic seals the penetration and prevents bridging between the damp substrate and new internal surface.
Applied to the fixing plugs before they are fitted, Newtonite 801 Mastic serves so as to seal the penetration and stop the occurrence of a 'bridge' between the damp or stained substrate and the new internal surface. Newtonite 801 Mastic has a high resistance to both ageing and extremes of temperature, as well as achieving a high adhesive strength, without primer, on the majority of materials used in the building and engineering industries.
Newton CDM BaseDrain & FloorDrain - Drainage System
Newton CDM BaseDrain and CDM FloorDrain is the drainage system used most commonly within the Newton CDM System − A range of products that collectively receive water ingressing at weaknesses within the structure and then discharge the collected water to a Newton Basement Pumping System or safe drainage.
The 18 mm holes drilled in both sides of the profile, as well as to the top surface, allows water from beneath the CDM Fibran XPS-500C insulation boards and within the spacer zone to enter the drainage channels more easily.
Newton HydroTank 315 Waterbar for Sealing Structures Against Water Leaks
A high grade, hydrophilic waterbar with high elasticity and high tensile strength, made from a polymer which swells when in contact with moisture, ideal for sealing structures against water leaks to both cast-in-place concrete and precast construction joints.
The swelling is achieved through hydrophilic acrylate polymers, which are inseparably embedded within the butylene carrier material. This results in high elasticity and exceptional tensile strength, even when fully expanded within the joint.
Due to its high resistance to acids, alkalis and organic solutions, HydroTank 315 Waterbar can be used to seal joints where aggressive water is expected such as within sewage treatment plants, biogas plants and liquid waste holding tanks.
HydroTank 315 Waterbar swells up to 9 times its original size when in contact with water, sealing the joint fully and reliably. The product is particularly suited to sealing non-compressed joints such as at the junction between slab and wall.
Newton Waterproofing
Unit 17-19, Sovereign Way, Tonbridge, Kent, TN9 1RH, United Kingdom
Newton Waterproofing Systems, est 1848, is the UK's leading independent supplier of structural waterproofing systems, including cellar and basement waterproofing, tanking and pumping products, damp proofing, water control and drainage products.