FlexProof 106 System

Polymer-modified, and fibre-reinforced, HydroCoat 203-RM is physically and chemically compatible with the host concrete, quickly exhibiting high adhesive and compressive strength. As a single component, requiring only the addition of water, the resulting mortar is rapid curing with enhanced polymeric properties and reliable strength development which is not significantly affected by low-temperature use.

The mortar can be used as supplied up to 100 mm deep, or it can be bulked out with sharp sand to form a high-performance screed or for floor or deck repairs up to maximum depth of 300 mm.

Surface preparation is required, as is protection after application - consult the manufacturer for details.

Features and benefits:

• Incorporates the latest proven cement chemistry, fibre and styrene acrylic copolymer technology.
• Reliable strength development, even at sub-zero temperatures, gives rapid return to service.
• Pre-packaged material only requires mixing with clean water. Can be bulked out with sand or aggregate.
• High bond strength exceeds tensile strength of concrete, thus ensuring monolithic performance of the repair.
• Sets in 10 minutes at 20°C yielding a durable, high strength mortar.
• Dense matrix resists 10 bar water pressure. Very high diffusion resistance to acid gases and chloride ions.
• Sulphate resistance to class DS-5/5m of BRE Special Digest 1 and ideally suited for sewage and wastewater applications.
• Portland cement base with physical properties of cured material similar to base concrete.
• Non-toxic when cured and is listed as authorised under Regulation 31 for use in the supply of drinking water.

Newton CDM 508 is a high quality cavity drain waterproofing membrane, supplied in a number of sizes and in 500g/m2 and 700g/m2 variants for use within the Newton CDM System, our internally applied waterproofing system that also includes drainage and pumping systems.

CDM 508 is suitable for waterproofing earth retained walls and vaulted soffits and floors. It is guaranteed against deterioration for 30 years, with a life expectancy of the design life of the building (DIN 9001:2000), and supported by BBA Agrément Certificate 22/6357.

CDM 508 is inert and non-polluting to drinking water, highly resistant to water, alkalines, saline solutions and organic acids, and not affected by minerals and hydrocarbons. It is also rot-proof, and resistant to bacteria, fungi and small organisms.

Highly advanced single-component liquid waterproofing material, which forms an elastomeric polymer membrane that is rainproof in minutes and capable of handling severe building movements and deformations.

The FlexProof 106 System is composed of two variants of the product, plus ancillaries:

• X1 − A thixotropic variant that is applied as a paste and so is suitable as a surface sealant over joints.
• NV − A lower viscosity variant that can be poured and is typically used within movement joints.
• FlexProof 106 Primer (Product code: 916) − Improves adhesion to porous surfaces.
• FoamStop (Product codes: FS1 to FS8) − Foam backing rod for movement joints.