Newton HydroTank 301-EP Metal Construction Joint Waterbar
Coated metal waterbar system used for sealing kickerless construction joints within retained concrete structures. It features an adhesive, reactive polymer coating on one of its sides which creates a permanent watertight seal that works immediately.
Installation is quick and easy with the waterbar fitted in place to the reinforcement steel with special clips so that after the placement of the concrete, the waterbar is fully embedded within the two adjoining elements, completely blocking the passage of water through the joint.
Because HydroTank 301-EP Metal Waterbar is not fixed to one of the concrete elements as is the case with conventional waterbars, the forming of a kicker is not necessary. Where the walls are formed above a kicker joint, use 315 Polymer Waterbar.
Newton HydroTank 301-EP Metal Waterbar is certified to resist water pressure of up to 5 bar (50m) and is resistant to all types of naturally occurring ground water types.
Other Products and Services from Newton Waterproofing
Newton HydroTank 315 Waterbar for Sealing Structures Against Water Leaks
A high grade, hydrophilic waterbar with high elasticity and high tensile strength, made from a polymer which swells when in contact with moisture, ideal for sealing structures against water leaks to both cast-in-place concrete and precast construction joints.
The swelling is achieved through hydrophilic acrylate polymers, which are inseparably embedded within the butylene carrier material. This results in high elasticity and exceptional tensile strength, even when fully expanded within the joint.
Due to its high resistance to acids, alkalis and organic solutions, HydroTank 315 Waterbar can be used to seal joints where aggressive water is expected such as within sewage treatment plants, biogas plants and liquid waste holding tanks.
HydroTank 315 Waterbar swells up to 9 times its original size when in contact with water, sealing the joint fully and reliably. The product is particularly suited to sealing non-compressed joints such as at the junction between slab and wall.
Newton CDM 520 eco Floor - Basement Waterproofing Membrane for Waterproofing of Existing & New Build Basements
BBA certified, 100% recycled 20mm cavity drain membrane for basement floors - with its 20mm stud profile, Newton CDM 520 Eco Floor is generally specified where it is anticipated that there may be a risk of severe water penetration.
Newton 520 eco is one of the main constituent parts of the Newton CDM System, our BBA Certified 'Type C' cavity drain system used for waterproofing earth-retained structures, including drainage channels sited below the membrane for increased drainage capacity.
With its 20mm deep stud profile, CDM 520 eco Floor is used within the CDM System as a high drainage capacity floor membrane and is generally specified where it is anticipated that there may be a risk of severe water penetration.
Flexible Construction Joint Waterproofing System - Newton FlexProof 106
Highly advanced single-component liquid waterproofing material, which forms an elastomeric polymer membrane that is rainproof in minutes and capable of handling severe building movements and deformations.
The FlexProof 106 System is composed of two variants of the product, plus ancillaries:
- X1 − A thixotropic variant that is applied as a paste and so is suitable as a surface sealant over joints.
- NV − A lower viscosity variant that can be poured and is typically used within movement joints.
- FlexProof 106 Primer (Product code: 916) − Improves adhesion to porous surfaces.
- FoamStop (Product codes: FS1 to FS8) − Foam backing rod for movement joints.
Newton Waterproofing
Unit 17-19, Sovereign Way, Tonbridge, Kent, TN9 1RH, United Kingdom
Newton Waterproofing Systems, est 1848, is the UK's leading independent supplier of structural waterproofing systems, including cellar and basement waterproofing, tanking and pumping products, damp proofing, water control and drainage products.